Version 1.50 (January 15th 2021)
51. External door handles not working in exterior views (OK in VR).
---FIXED---
52. Move low fuel warning to supply tank.
---COMPLETED---
53. Check supply tank drain times.
---COMPLETED---
54. Add commands for the 4x fuel switches.
---COMPLETED---
55. Conversion to EMS / Air ambulance variant.
---COMPLETED---
56. Increase HYD trim rates.
---COMPLETED---
57. Update Manual.
---COMPLETED---
58. Take out of Beta.
---COMPLETED---
Version 1.40 (January 15th 2021)
28. Move away from "wing-sweep" throttle axis and go back to standard throttles.
---COMPLETED--- This will be a trial version, wing sweep has gone, standard X-Plane throttle now in use, this gives better "dual" throttle control and will allow implementation of the engine power trimmer.
38. Trims not working.
---FIXED---
39. Remap main body UV to include the plate below the clamshell doors. (Could effect existing liveries).
---COMPLETED---
40. Implement engine RPM trimmer.
---COMPLETED---
41. Co-Pilots collective encroaching on the seat.
---COMPLETED---
42. Remap Collective head and add 4 way china hat for search light and 2 way china hat for landing light.
---COMPLETED---
43. Animate engine trimmer / china hats on collective.
---COMPLETED---
44. Commands added for engine trimmer / up / down / reset.
---COMPLETED---
45. Landing Light - Extend / Retract now fully working with animated china hat and commands added to the menu options.
---COMPLETED---
46. LIT texture added to collective head.
---COMPLETED---
47. Search light functions PAN left / right / up / down added
---COMPLETED---
48. Added a LIT texture for the aircraft folder.
---COMPLETED---
49. Command added to MUTE the RPM needle split warning horn.
---COMPLETED---
50. Fuel pump switch operation now working.
---COMPLETED---
Version 1.30 (January 2nd 2021)
https://forums.x-plane.org/index.php?/forums/topic/257951-mbb-bo-105-development-notices/
29. Investigate "death pitch up" at - altitude / weight / speed - > 5000 ft / >2300 kg / > 80 Kts
---FIXED--- Including with the Experimental flight model.
30. Over-pitching instability tuned out.
---COMPLETED---
31. FMOD - Re-evaluate internal rotor sounds.
---COMPLETED---
32. FMOD - Adjust other requested changes where applicable.
---COMPLETED---
33. Engine power increased for better high altitude operation's.
---COMPLETED---
34. Spelling corrected Thanks to user "bwitched" for spotting these!
---COMPLETED---
35. Move rear beacon from the rotor gearbox to the tail section.
---COMPLETED---
36. Main body - minor adjustments.
---COMPLETED---
37. TOT not rising with altitude
---FIXED--- May need some fine tuning.
Version 1.20 (December 27th 2021)
1. DME Lamp - still on after battery / Main Bus feed - off
---FIXED---
2. Storm Lamp - still on after battery / Main Bus feed - off
---FIXED---
3. Cabin Lamp - still on after battery / Main Bus feed - off
---FIXED---
4. Main Panel Rear Corners - are touching interior glass.
---FIXED---
5. Animations on Radio Flippers have gone?
---FIXED---
6. Adjusted "light spills" on navigation lights
---COMPLETED---
7. Make sliding window "outer" an external object to get reflections.
---COMPLETED---
8. Fuel pressure needles - Not active during replay mode.
---NOT FIXED--- X-Plane does NOT generate fuel pressure values in replay mode over the value of 1???
9. Adjust FMOD front window open sound to be less than open door sounds.
---ON HOLD---
10. Strobes still active with BATT off.
---FIXED---
11. FMOD sound error with engine 1 vent run.
---FIXED---
12. FMOD sound error with engine 1 / 2 vent run - switching the BATT off.
---FIXED---
13. Investigate TRQ gauge differences between 2D / VR and replays.
---FIXED--- Requires testing on different customer systems.
13a. Now 13 (above) is fixed, we can re-calibrate the TRQ gauge.
---COMPLETED---
14. Rotor blur shadows - to be removed and switch to original rotor blur (as per the quick fix on the forum).
---COMPLETED--
15. Adjust FMOD rotor sounds.
---COMPLETED---
16. Decent Rate Increased.
---COMPLETED---
17. Increase ROLL RATES.
---COMPLETED---
18. Increase Starter SWs click zones.
---COMPLETED---
19. Starter SW manipulator changed to "HAND" type as was not working with G2 VR controllers.
---COMPLETED---
20. Compass SYNC indicator removed and replaced with TRIM indicator gauge and lighting increased.
---COMPLETED---
21. ELEVATOR trim replaced for ROTOR trim and added to trim indicator gauge.
---COMPLETED---
22. Assigned a panel SW to reset control trim.
---COMPLETED---
23. Cleared foggy glass on trim gauge
---COMPLETED---
24. Minor texture fixes to panel / pedestal.
---COMPLETED---
25. Removed "dust texture" on INSTR glass and merged into one file.
---COMPLETED---
26. Fixed a graphic error where the pedalstal meets the main panel.
---COMPLETED---
26. Moved CWP glass to in front of the annunciators.
---COMPLETED---